5WG1524-4DB23

- Rated current: 6 A - Number of channels: 2 - Dimensions (W x H x D): 48 x 87 x 36 mm - Warranty: 24 Months

• 5WG1520-2AB03

• 428488740

• S55561-F256

• S55230-V128

• S55204-V132

• S55195-A127

• S55560-F102

• GIB331.1E

• S55264-V134

• S55230-V289

• For control of drives with a DC motor for DC 24 V
• Two relays per output for polarity switching of the output voltage
• Rated contact operating voltage DC 24 V
• Rated contact current: 6 A
• Electronics for detection of the actuation of an electromechanical and electronic limit switches
• Automatic travel time determination via current detection
• Maintenance-free terminals for connection and through-wiring of untreated single-core, stranded or multi-core conductors, 0.5 … 2.5 mm²
• Two terminals per actuator channel for motor connection (up, down)
• Two terminals on the device to connect the DC 24 V (+/-) to supply the load circuits
• Bus-powered electronics
• Housing: plastic
• As built-in device for mounting in a separately to be ordered Control Module Box AP 118
• Type of protection: IP 20

Additional functionalities GAMMA

• Selectable operation mode blinds, shutter/awning, ventilation flap
• Per actuator channel motion commands for moving and stopping the solar protection or for adjustment of blind slats
• Per actuator channel direct movement to a position of the sunblind and the blind slats
• Per actuator channel central movement of the solar protection in manual mode and automatic mode and delay time for Up / Down
• Distinction between automatic and manual mode (position of the sunblind and blind slats) and adjustable behaviour in sunshine
• Programming and recalling preset positions 1-4 and 8-bit scene control
• Adjustable behaviour in case of override (wind, rain, frost, lock, forced position, forced control, range limitation)
• Adjustable reverse pause time and delay times of the drives
• Per actuator channel configurable state on bus voltage failure and start value on bus voltage recovery
• Adjustable transmission of status objects (automatic operation, curtain and slat position, travel, calibration travel time to end positions, overriding) on request, cyclically and/or upon change
• Adjustable transmission time of the status objects after bus voltage recovery and transmission delay between the status objects
• Surveillance of device function

Additional info
The automation module box AP 118 must be ordered separately.See chapter Modular installation system, Room automation box – Housing.